Bazhou Hardware Stamping Parts Factory, the overall solution of stamping parts + improve assembly production efficiency by 17%

The production staff of Bazhou Hardware Stamping Parts Factory said that most of the causes of metal stamping parts' unevenness are caused by dust or iron filings attached to the raw materials or the appearance of the mold. It degrades the appearance of the product and also greatly reduces the productivity. So how can we avoid this problem? The following Xiaoshuo summarizes the following effective methods to reduce the bumps of metal stamping parts based on the practice, and let everyone take a look. 1. Inspection and correction of the drawing die: The drawing die needs to be regularly inspected and maintained to reduce the occurrence of bumps and maintain a stable state. The usual method is to use samples to check the bonding scratches and processing surfaces of the blank holder (die fillet, punch fillet). 2. Inspection and correction of the shearing die: The reason for the unevenness after the shearing process is that iron powder is produced during the shearing process. Therefore, the iron powder must be observed before punching to avoid the occurrence of unevenness. 3. Check the cut surface: When cutting the coil material, the wear and breakage of the cutting die will produce a lot of tiny iron powder attached to the cutting edge, so the double cut surface must be checked in the material area or the press line before stamping production, and cleaned in time The sheet is deburred. 4. Inspection of sheet material cleaning device: It is necessary to inspect and trim the cleaning device at the same time before stamping production, so that it may clean the sheet material more effectively. This is also very necessary, and also needs to pay attention to the roller gap and the quality of the cleaning oil. The detailed method is to apply red paint on a steel plate to make it clean and settle. Currently, check the antecedent shape of the red paint being cancelled. If the removal rate is not up to the standard, it is necessary to check, trim, clean and settle. Hardware, 15 years of focus on Bazhou metal stamping parts factory, hundreds of processing and production equipment, 20,000+ sets of customized stamping die production experience, monthly processing volume of 100+ sets of molds, daily production capacity of 3 million punching times, and stamping accuracy up to 0.01 mm, 16 quality inspection layers are strictly controlled, focusing on quality and meticulous design. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose rest assured!