Introduction to the detection of metal stamping parts
Metal stamping parts of hardness test using rockwell hardness tester.
Small, stamping parts with complex shape, can be used to test the plane is small, can't test on ordinary desktop rockwell hardness tester.
Stamping parts processing, including blanking, bending, deep drawing, forming and finishing process.
Stamping parts processing materials is mainly hot rolled or cold rolled (
Metal materials, such as carbon steel, alloy steel, spring steel, tinplate, galvanized sheet, stainless steel plate, copper and copper alloy plate, aluminum and aluminum alloy plate, etc.
PHP series portable surface rockwell hardness tester is applicable to test the hardness of the stamping parts.
Metal stamping parts is the most commonly used metal processing, machinery manufacturing parts.
Stamping parts processing is the use of mould making metal plate processing method with separation or forming.
Its application range is very wide.
Stamping material hardness testing, its main purpose is to determine to buy the sheet metal annealing is suitable for stamping parts processing, then are going to do different kinds of stamping parts processing, need different hardness level of plank.
Used for stamping parts processing of aluminum alloy plate Webster hardness tester tests are available, and the thickness of the material more than 13 mm can convert barcol hardness tester, pure aluminum or aluminum alloy plate should use pasteurized low hardness hardness tester.
In the stamping industry, such as shenzhen chong hing hardware products factory introduction sheet stamping sometimes called forming, but a little difference.
Sheet forming refers to the use thin plate, thin wall pipe, profile as raw materials such as plastic processing and forming method of a general designation for the sheet metal forming, at this time, the direction of the plate deformation is generally not considered.
A: simple introduction of card buckle