Metal shell mould safety operation

Metal shrapnel mold in stamping process, high speed punch to have a higher risk. In case of improper operation, the mould will cause serious damage, and operator safety will also be hurt, so the mold to machine, be sure to keep in mind the following operation, to ensure the safety of the mold and the operating personnel. Metal shell mould board notice: 1. Before pulling mould, check to ensure that the mold inlet of material plate is loose. 2. Mold does not move when one person to pull, backward. ( Avoid by all means backward at the same time, two people will launch punch mould platform) Can be used to carry die mold base under the screw to rotate the screw hole, his hands at the same time pull up a little after. 3. Metal shell mould pull out of the punch mould cars cannot be turned too sharply and prevent the guide plate or material plate punching machine or punch in the enclosures, cause mould parts damaged or mould slide. 4. Abnormal lower die not again when the inching operation, especially in check after the tall secretory pad plastic mould. 5. Die after lower die to punch the host and other power shut down, avoid the waste of resources. 6. Metal shrapnel moulds normal downtime should be inching operation to guide the needle into strip round hole. It is strictly prohibited to will die in the bottom dead center. Benefit is building, safety is the cornerstone. Dongguan precision electronic technology co. , LTD focus on metal shrapnel and various consumer is tasted and mold development and production for years, regular employees on personnel matters of safety education and training, has been to production safety discharge in the first place, the customer's property protection to every employee in the heart of the propaganda. Precision contact: wish you a prosperous business, everything goes well, if you want to learn more dynamic, can scan the qr code, pay attention to the public. , is committed to precision stamping processing factory of the world's most professional electronic components