Metal stamping parts processing and common adverse phenomenon
by:Fortuna2021-02-15
Metal stamping parts processing bad common phenomenon: 1.
The surface of the steel plate or a foreign body inside, with foreign bodies fall off, coil in as the state of the scar.
2.
Scratches,
The roll surface or different material)
, the edges (
20~30mm)
Due to the stress non-uniform deformation or crushed, coil edges broken.
3.
Due to sliding roller, foreign bodies in the coil back pressure after entering the bulge (
Foreign bodies fall disappear)
。
4.
Irregular edge breakage, beyond material fault rule.
5.
Roller trace (
Foreign body attached on the roll)
Influence, caused by foreign body surface depth.
A: stainless steel stamping processing main application is introduced