Metal stamping parts processing is the requirement of bending parts

1. Bending shape should be symmetrical, must not be smaller than the minimum bending radius of the material allows the bending radius. 2. Curved short not easy forming, reason should be bend the edge of the straight part H> 2δ。 If the required H is very short, the need to set aside the appropriate to increase the allowance H, good bending after all increase of metal cutting. 3. The bending with hole, in order to avoid deformation of the hole. Zp8 metal stamping parts processing factory in shenzhen followed by the requirement of deep drawing parts. 4. Metal stamping parts appearance should be simple, symmetrical, depth shoulds not be too big. So that the drawing number, easy to take shape. 5. Metal stamping parts of radius under the condition of without any increase in process. Otherwise will increase the drawing number and plastic work, increase mold number, and prone to waste and to improve the cost. Dongguan metal stamping parts, plastic wood card clasp, stainless steel metal stamping processing, dongguan dongguan stamping parts processing, dongguan stamping processing plant in the previous: introduction to the principle of stamping process design