Precision metal stamping parts clip-on feeder adjustment notice
by:Fortuna
2021-02-03
Precision metal stamping parts production, need to choose good corresponding auxiliary equipment to produce high quality products, when you choose high quality suppliers, Suggestions will be incorporated into the examination scope.
Precision stamping parts manufacturers want you to think, think you not want to, it has a full set of advanced production machinery and equipment, can in the shortest production time, the best quality and most favorable products.
1.
When the feeder clamp pad wear, its thickness adjustment is again the scribed line shall prevail.
2.
The adjustment method is: the first one hand clockwise adjust material thickness plate, pull the strip, if the material can be pulled, need to slowly counterclockwise, until the material does not move again after the two little counterclockwise, then lock locking screw.
If the material does not move, but the material thickness adjustment plate clockwise or counterclockwise are leaky, need finger slowly and gently rotate clockwise, but is not available, vigorously until turn counterclockwise again after two little, then lock locking screw.
3.
Two little back to the material clamping, prevent caused by different material thickness is expected to die.
Material thickness control is + / -
0.
01 mm4。
After moving clamp material thickness to adjust, need to punch the flywheel shake to 90 degrees clockwise, to check whether mobile clamp has been in a state of clamping.
In 90 degrees adjustment clamp material thickness, feed clamp clamping loosen first master switch to open, in the mobile put 1 clip material thickness adjustment plate.
5 t material, will move the clip is expected to hold up not stuffing, and then the material through the clamp, and then will feed clamp clamping loosen master switch is, and then according to the moving clamp material thickness adjustment method of clamp material thickness.
5.
In the 90 degrees still need to adjust the feeding step distance.
6.
Step away from the adjustment, the feeding clamp clamping relax main switch must be set to open, will move clip material thickness of the adjusting plate put material, will press the flywheel away first stripper guided needle into the next mode floating pin hole two-thirds, adjust the feeder relaxation time.
7.
Will punch across 180 & deg;
Guided needle straight segment is going to leave the strip, need to check whether the clamp clamping at this time, if no clamping, in accordance with the relaxation method dispatch material to clamp.
8.
Adjust need to run a circle, after checking at each point of feeder mobile clamp and the clamp of cohesion.
9.
If the material through the feeder to mould inlet material below or above the height of the mould inlet, need to adjust height of feeder.
Dongguan precision electronics co. , LTD. Is a company specializes in precision metal stamping parts stamping processing manufacturers, the company in July 2009 through the ISO 9001:2008 and ISO 14001:2004 certification.
Implement TS16949 quality system certification in 2013.
In July 2014 through certification.
The future, will continuously deep tillage technology, based on the precision electronics, automobile, medical connector field.
Precision contact: wish you a prosperous business, and treasures will be plentiful, if want to know more dynamic, can scan the qr code, pay attention to the public.
, is committed to precision stamping processing factory of the world's most professional electronic components
Custom message
Related Products