Precision stamping die is on the mold base and mold base, the mold base and stripper of four parts.
In order to shorten the stamping mould processing cycle, to strengthen the mould precision, spinning technique, the operator a lower mold production will produce abnormal, ensure production quality and the die life, especially for precision stamping die each component of the assemblage.
1)
Under the lower die glue: template by positioning Pin and the mold base precise positioning, and the screw fastening, with 680 glue to glue the Pin between the glue.
This process should be to ensure that the glue adhesive is strong;
2)
Upper die glue: template and the template on the pay guide pillar to ensure accurate positioning, ensure that after the two parallel at the same time, by the screw tighten template and the mold base on.
With 680 glue to glue the PIN glue between the two.
This process should ensure the parallelism of upper and lower mould, location accuracy;
3)
Precision stamping die assembling: the upper die and lower die clamping, after clearance by viewing the template to ensure parallelism, leading column using AB glue or quick-drying glue glue.
This process to ensure that the leading column is not higher than the mold base and glue adhesive must be strong, dominant set of about 5 mm below the upper die seat surface;
4)
Shell plate group set: the strip plate material into the son, Pilot, shell plate forming workpiece, strip material (
Pushing rod)
Into the strip plate, such as the strip plate material into the son to make sure nothing is higher than that of shell plate, in addition, to ensure that the strip plate back to blocking material into the son, forming the workpiece, the Pilot, strip material, such as set of retreat;
5)
Bottom template group: will die, forming mould kernel, Lift, guide plate loaded on the cavities fixed plate.
This process shall ensure that the cutting mould kernel is not higher than the surface, blanking mould kernel edge up, Lift and other activities cavities freely, etc. ;
6)
Formwork group: fix plate punch inserts, punch load on the template, and use clamp to fix punch, also ensure that the child can't higher than the mould surface.
7)
Clamping: without put a spring in the upper and lower die, to die eight boards stick, punch and strip plate relative position is correct, if the template and forming punch interference, etc. ;
8)
Mount Stopper, Disk, such as sleeve, spring, Sensor, suction device, etc. , and on the mold base front mould number, number, Pitch, such as raw materials, precision stamping die parameters.
High speed precision stamping dies, precision 30 years professional production suitable for to mass production of high precision products.
If the connector terminals, electronic accessories, can be continuous plating and assembly automation.
Mold production speed is 200 -
1500 SPM/minutes, the die life can reach more than 100 million times.
Precision contact: wish you a prosperous business, and treasures will be plentiful, if want to know more dynamic, can scan the qr code, pay attention to the public.
, is committed to precision stamping processing factory of the world's most professional electronic components
