Precision stamping die structure of precision stamping parts precision and quality, but we tend to overlook the security of stamping mould, security is also when I was in the design of stamping die must be considered.
Below summarizes some mould for everyone using the design of security problems: 1, should try to ensure that feed on structure, material, parts, easy to clean up the waste.
2, for large precision stamping parts processing, if the operator must hand into the mold, as far as possible reduce the range into the mold, shorten a portion of the form in the time duration of the mould, and shall specify the mould of danger area, equipped with the necessary protective measures and devices.
3, for small precision stamping parts processing to prohibit the operator's fingers, wrist, or other parts of the body into the area of mold;
4, mold design, the general layout of should indicate the mold weight, easy to install, ensure safety.
More than 5, 20 kg of parts processing should be lifting handling measures, reduce labor intensity.
6, mold parts should be convenient and safe installation and avoid a possible clip, cut hand;
Mold storage to facilitate disassembly.
7, not to be allowed to happen in the process of machining precision stamping waste or workpiece missile phenomenon, affect the operator's attention, even by the operator.
8, are not allowed to have a too difficult and too much homework.
9, should try to avoid stamping processing has strong noise and vibration.
10, the various parts of the mould should have sufficient strength and stiffness, prevent damage and deformation in the course of using, fastening parts must have the loose prevention measures, avoid accident harm to the operator.
11, to avoid the precision stamping burr cut staff.
Do not allow the operator to stamping operations there is too much movement range, avoid lose body stable posture;
In short, even a minor problem in mould will affect the safety, only to analyze the specific problems of each homework, can put forward security considerations in precision stamping die.