Problems that must be paid attention to when processing metal stamping parts waste

In the metal stamping production, because the hardware is mass-produced, there will be a lot of waste. The processing of these metal stamping waste is an extremely dangerous job. It is best to use automated equipment for processing, but some Waste materials have to be processed manually, so what should be paid attention to when processing metal stamping parts waste? There are two types of metal stamping parts waste packaging processing, one is automated processing, and the other is non-automated processing. 1. Safety measures for automatic processing of metal stamping parts waste: 1. When general sheet materials are used for processing, the metal stamping parts waste is conveyed by a conveyor belt, cut short by a waste shredder, and then pressed into squares by a press. 2. Use a take-up reel to wind the scrap. In fact, the take-up reel looks similar to a strip steel reel. After the metal stamping parts are wound on the take-up reel, the scrap can be used as a material for other parts. Since the reel motor is independently driven, it can also be driven by a press or a feeding mechanism. 3. A cutter is set on the metal stamping die to cut off the waste, and then it is conveyed by the conveyor belt to the baler to press the block. Pay attention to the process The time interval of the press is cut off at a certain distance. 2. Safety measures for non-automatic processing of metal stamping parts waste: 1. When the waste of punching small holes is discharged obliquely, the waste should be automatically broken into layers, and at least 100 pieces of waste should be stored at the upper mold or lower mold base. , If the two local wastes are collected together, there must be enough space for stacking. 2. It is best not to handle the waste with sharp corners or burrs to prevent injury to people, and the size of the waste should be appropriate when cutting the waste to prevent injury to the operator when it is near the operator. 3. When the waste passes through the pipeline, we must pay attention to it if the width and height in the straight line are not good, it will easily block, and we must try to prevent more than two kinds of waste materials from passing through one kind of pipeline. 4. The chute for removing waste must pass to the end of the backing plate and be aligned with the opening of the waste pit. When installing the chute, pay attention to whether the screws of the metal stamping die are tightened. 5. If the metal stamping waste cannot fall by its own weight, once it hangs on the edge of the blade, it should be forced to fall by using throwing, ejection and other falling aid equipment. 6. In order to ensure safety, a protective cover should be installed when the metal stamping parts are not automatically processed nearby, and the waste should not be allowed to flow out or scattered near the operator during operation. The above is a brief introduction to the issues that should be paid attention to when handling metal processing waste. Here, we also remind the personnel engaged in waste packaging to pay attention to safety and prevent the occurrence of dangerous incidents. Recommended article: How to maintain and maintain stamping parts processing equipment Previous: Discussion on the impact of metal stamping die blanking clearance on the quality of stamping parts