Security electronics hardware stamping mould processing matters needing attention

Security electronics hardware stamping mould processing note: 1, the security of electronic hardware stamping die template warp ( 0. 006/100mm) , the thickness is very poor ( ± 0. 002mm) 。 2, hole processing, must not processing, processing of phenomenon. 3, adjusting screw groove width and depth. 4, the depth of the screw holes and vertical degree, rotate smoothly. 5, the activity type guide pin hole mobility, positive countersunk hole depth. 6, security electronics hardware stamping die activity, the activity. 7, mouth and into the block matching template box. 8, security electronics hardware stamping die off into the boards hanging seat depth. 9, confirm the number of the template size. 10, can try to punch through the stripping into pieces. 11, floating and pin R Angle increases and polishing. 12, bending forming prepressing pressure spring force. Into the block size 13, on, under the activity is not consistent, avoid creasing. 14, security electronics hardware stamping die assembling into blocks ( Especially take off into the boards) With no heat treatment of flat iron hammer out.