Stamping process in stamping workers should pay attention to matters

Dongguan precision electronic technology co. , LTD. , established in January 2008, is a professional design and manufacture of precision stamping die and precision hardware stamping ODM/OEM professional manufacturers. Professional stamping production precision terminal, shell parts, precision shrapnel and other hardware. Products are widely used in precision connector terminals, relay shrapnel, micro-motor shell, IC lead frame, car terminal, household appliances precision shrapnel, intelligent electronic components, medical terminals, such as consumer is tasted. In stamping machining operations must be pay attention to the items: the operator must know stamping equipment types, specifications, performance, to class four check: check hand-over records, electrical appliances, check safety device, mould; Do a person, point, qualitative, quantitative and add lubricating oil regularly; With photoelectric protection circuit of press, should first before starting the commissioning photoelectric suitable job position and commissioning; Check mold fixed situation, the safety device before starting work, everything is ok before test, local train running a week later, the car idling 2 - again 3 min, check device and the lubrication situation after normal operation, may work; When installing the mold with a slow train adjustment, do not overload use press; Installing a play device, the slider will stop at the top dead center; Press in the process of work, it is strictly prohibited for its cleaning and lubrication and die; To place billet in the die and when removed from the die components, be sure to use the right tools. Press start later, it is strictly prohibited to readjust the position in the billet in the die; Slider after each shock, should handle leave press switch or button, operating lever, to avoid danger when artifacts from die; Operations must be focused, forbidden hand into the mold fit range, in strict accordance with the technical requirements for operation; When two or more persons, should be a person drive a car, cooperate with each other well. After emergency stop, and then to production, machine before and after the workers must play called unified, coordinated action. Medallion electricity protection switch; If meet an emergency, press the stop button, troubleshooting, and continue to work. Generally do not press stop button, to reduce the damage of machine tools; Worktable is prohibited place has no fixed tools, and other sundry, mesa place raw parts, its height must be less than use pattern height more than 50 mm; Repair or must stop when the above mould, machine tool must be listed beside the switch or switch. Grinding pressure bed in the mould, the mould guide pillar and guide sleeve cover tightly; Machine tool slide and electrical failures occur, should immediately stop, find relevant personnel to repair. It is forbidden to equipment belt 'disease'; After work to cut off the power and stop the motor running, turn off the air valve. The slider at the top dead center, the device is in idle state, and fill out all kinds of records; When wipe billet and clean up the waste, must bring gloves, in order to avoid hurting hands; Do a good job in production, implement each rules and regulations; New workers must carry out safety education and pre-service training, team is responsible for; Strictly implement safety operation procedures; Finally, stamping processing factory to give the company staff to do safety education training, training should also be targeted. Let the company's personnel seriously rise, prevent the hoops.