One Stop Solution Manufacturer for all kind of Stamping Products and CNC lathed products.

The common problems in automatic stamping process

by:Fortuna     2021-01-30
Automatic stamping press is equipped with program control system of automation equipment, compared with the ordinary press, its a bit is: high speed, high precision, high efficiency, intelligence, and cost savings, the automatic pressure set the advantage of opportunity won't have a problem? We learn about the. 1. Automatic stamping material scratch: cut apart from incoming bad, may be put in when staff does not reach the designated position, need to be careful on the rack to avoid scratch, it is strictly prohibited in the tray and the ground and drag, friction material on the shelf; 2. Deformation: install mould nowadays die too short, mould interval of interference, too close to punching parts, stamping deformation; 3. Automatic stamping die displacement: install mold die today is too high, the deformation, caused by raw materials mold not punching, blanking, the accuracy of press down; 4. Embossing: incoming surface embossing, crushed, mould on the impurities, no demagnetization, may cause the stamping; Above is summarizes the problems in the production process, automatic press is for reference only, if want to know about the solution, we can continue to attention, the above article is derived from the metal stamping parts, automotive stamping parts processing custom 18 years of enterprise original, reproduced please indicate the source. 【 Relevant recommendation 】 Details: how much do you know the new energy automotive stamping parts? Details: sharing details of stamping processing industry: precision metal stamping parts figure how to draw, please be aware that this several steps
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...