Thickness of material of die mold base group of terminals

1, the thickness of material terminal mold, the mold base outside with general (8 ' 20cm) Of long ping bravely, remove burrs and sharp edges. 2, mold base on the positive, on the back of the mold base all orifice chamfering R0. More than 5, Φ 12. 000 location hole loading end circumference R1. 0 and polishing, led column hole loading end circumference R1. 0 and polishing. 3, on the back of the mold base all around the blanking hole C0. 5 ( Positive fail) 。 (4), the thickness material terminal, the mold base with 600 # ( 200 * 54 * 27) Sharpening stone bulldozed to remove burrs. 5, the upper and lower mold base with kerosene wash clean, use air gun to all through hole bits of the cut after a blow to clean, wash clean with alcohol again. 6, will lead column in side coated with a little oil, gently knock down into the mold base guide pin hole. ( Pay attention to the vertical degree, need to prepare the light and Angle square) 7, build up and mold base, with special glue positioning pin, the mold base location OK. 8, will dominate set clean, into the mold base on the dominant set of holes. In each guide bush around four directions in 0. 03 ~ 0. 04 silicon steel sheet, and check each guide bush can turn into silicon steel sheet later. 9, first take a guide sleeve around the LOT - By rotating the pressure into the 680, and then slowly until met T = 48. 0 mm block, the guide sleeve top sink into the mold base plane about 1. 0mm。 10, mold base on the thickness of material terminal side before carved: model number, material, mold clamping height, PITCH, material thickness and width. Precision contact: I wish you all a happy New Year and all the best, if you want to learn more dynamic, can scan the qr code, pay attention to the public. , is committed to precision stamping processing factory of the world's most professional electronic components