What's wrong with the feeding of molds in stamping parts?

Metal stamping parts processing plants process all kinds of metal stamping parts, stainless steel stamping parts, special-shaped parts, etc. In the stamping part processing, when the mold is fed, sometimes it is not smooth. What is going on? Let’s take a look at the following; the reasons for the unsmooth feeding are: 1. The mold may not be set up correctly, causing the material belt to be out of the same straight line with the feeder and the mold; 2. The material belt is not flat; 3. The mold is not unloaded and the material is not fed. Straight; 4. Positioning is too tight; 5. The guide pin is too tight or the straight wall is too long; 6. The punch is not fixed well or too long to interfere with the material belt; 7. The ejector pin is too short, and the material belt and the forming Block interference; 8. Improper arrangement of floating blocks; 9. Insufficient avoidance causes interference; these reasons will cause mold feeding to be unsmooth, so regular inspection and maintenance of molds are very important. Article recommendation: What is the hazard of the eccentric load of the press used in the processing of stamping parts? Previous post: How to choose a press for processing stamping parts