10 aspects that need to be paid attention to in the debugging process of stamping die

The mold needs to go through multiple trials and repeated modifications to complete. In order to improve the stability of the mold and avoid losses due to problems that shouldn’t occur, precision has accumulated rich experience in production practice and summarized the stamping processing plant’s 10 aspects that should be paid attention to when debugging the stamping part die: 1. The strip used in the test mold should be kept straight and free of impurities in the length direction; 2. The stamping part plate used in the test mold, its brand and mechanics The performance should meet the requirements specified on the product drawing; 3. When trying out the mold, the stamping part mold should be used on the required designated equipment, and when installing the die, it must be installed firmly; 4. The strip used for the test mold The width of the material should also meet the requirements specified in the process regulations; 5. Before the debugging of the stamping part die, the punching die must be inspected in all aspects. After the inspection is correct, it can be installed on the press; 6. Each movable part of the punching die is Lubricant should be added for lubrication before mold test; 7. Before mold test, check whether the unloading and ejector are flexible; 8. Look at the die edge, sharpen and trim in advance, and check the uniformity of some gaps. It can be installed on the press after confirming that it is suitable; 9. The stamping part at the beginning of the trial mold should be carefully inspected. If it is found to be unqualified or the mold action is abnormal, it should be shut down immediately for inspection; 10. The product after the trial mold , Generally no less than 20 pieces, and keep them properly, so as to be used as a basis for the delivery of the mold; [Recommendation] Learn more: Notes for designing continuous stamping dies (2) Learn more: 6 considerations for designing continuous stamping dies Details: Analysis of the cause of the bursting of the stamping die