Aluminum alloy stamping, the inspection work that needs to be done before production and processing [hardware]

Aluminum alloy stamping requires the stamping factory to pass the inspection of the first part before the production process. At the same time, it is necessary to conduct all-round inspections on the stamping machine and stamping dies to ensure the quality of the process and the stability of equipment and molds. Xiaoshuo will work with you to understand the inspection content for the mold: 1. Perform cross-section inspection and analysis of the workpiece and waste, inspect and repair the trimming and punching gap; inspect the cutting edge and edge angle of the insert, punch, and die Repair; check the cutting knife and punching depth. Check and optimize the length of the scrap cutter; check whether there is any abnormal waste in the mold, and check the integrity of the scrap chute, so that the waste can be discharged out of the mold reasonably and smoothly. 2. Detection of the return spring: check whether the mold spring and other mechanisms are working properly to ensure that the mold returns correctly; whether the lubrication is normal. 3. Inspection of stamping die parts: check the list of standard parts of the mold to ensure that there are enough parts in the warehouse; check the vulnerable non-standard parts of the mold to see if it can work normally. Hardware, 15 years of ingenuity focusing on aluminum alloy stamping, 20,000+ sets of customized mold production experience, monthly 100+ sets of mold processing capacity, 3 million punching times per day, stamping accuracy up to 0.01mm, 16 quality inspections strictly for quality control. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose rest assured!