Analysis and application of automobile stamping parts

Automobile stamping parts are stamping products used in automobiles, which are very important to the operation of automobiles. When stamping processing plants are processing automotive stamping parts, they need to analyze some of the characteristics of automotive stamping parts in order to better produce. Next, Precision will introduce the analysis and application of automotive stamping parts. 1. To effectively set the process hole to solve the problem caused by the material, the production staff selects the appropriate part to punch the process hole when the blank is stretched, and can also carry out the stamping process at the volatile part during stretching. hole. The process hole produced by stamping production should be of suitable size, and it cannot be too large or too small. If the process hole is too large, the metal stamping part is very easy to cause the situation of turning the hole; if the hole is too small, the top of the process part cannot be sufficiently obtained, resulting in the material cannot enter the part, and then the periphery of the top process hole will shrink. The condition of the trail. 2. Effectively set process supplements. Process supplements in auto parts provide the basis for standard parts. During the production process, material supplements are carried out under the precondition of stamping parts, which not only has an important relationship with the forming of blank stretched parts, but also It also has a close relationship with the development of related technological processes. During the whole production process of automobile stamping parts, when there are large vacancies in the stretch-formed parts, because the blanks cannot be supplemented by external materials during stretching, there is a huge loss of parts that fail to pass. In order to better reduce the occurrence of this situation in the automotive industry, after carrying out relevant analysis and scientific research, the decision was made to vacate the material resources that need to be supplemented in the pre-forming link of the rough embryo, and to assist the conversion of the vacant rough embryo to obtain an immediate supplement. 3. Improvement of mold manufacturing For common parts in the automobile industry, if the upper and lower sides of the parts need to be improved, in order to better ensure the convenience of the actual operation of the process, the actual operation of placing the parts can be easily carried out to complete the manufacturing. Under normal circumstances, auto parts molds often use the structural blanking method of two-side wedges. [Related Recommendations] Learn more: About the plan for increasing the utilization rate of stamping parts. Learn more: How can the structure of stamping parts be reasonable. Learn more: How to avoid the bumps and convexities of metal stamping parts