Analysis and treatment of the problem of non-discharge of stamping dies of stamping parts manufacturers-hardware

In the production of stamping dies, stamping parts manufacturers sometimes encounter problems such as non-discharge of metal materials. The lighter stamping parts product overlaps and damages, and the heavy one will cause the stamping die to break and so on. So what kind of situation will produce this phenomenon, and how should we deal with it? Xiaoshuo shares with you: (1) Improper positioning or improper feeding. Adjust the positioning or feeding device. (2) Insufficient avoidance for grinding and avoidance. (3) The inner guide post is strained, causing the board to be ineffective. Replace the inner guide post (4) ) The punch is strained or the surface is not smooth. Replace the punch (5) Unreasonable positioning of the ejector pin. Re-orientate the ejector pin position. (6) Insufficient ejection force or insufficient ejection force. Replace ejector spring or ejection spring (7) ) The punch and the splint do not cooperate smoothly. Repair the punch and the splint to make the punch cooperate smoothly. (8) The forming slide block does not cooperate smoothly. The slide block and the guide groove are not matched smoothly. After the deformation, re-grind and beat the board to correct the deformation (10) The punch is too long or the length of the ejector pin is not enough. Increase the length of the ejector pin or use a punch with a suitable length. (11) The punch is broken. Replace the punch (12) The template is not clouded. Magnetic, the workpiece is brought up to the template demagnetization hardware, 15 years of ingenuity and dedicated experience, one-to-one service for each customer's customized needs. A stamping parts manufacturer with a monthly processing capacity of 100+ sets of molds and a daily production capacity of 300. Choose, choose to rest assured!