Analysis of the Causes of Poor Size of Metal Stamping Parts

Metal stamping parts are a kind of metal products that are widely used, and can often be seen in our lives. While metal stamping parts may have some quality problems during production and processing, this article will analyze the reasons for the poor size of metal stamping parts. 1. Poor mold design or processing and assembly lead to poor dimensions. This situation usually occurs during the first production. 2. When setting the mold, the height adjustment position of the mold does not match, and the mold cannot be in place during the metal stamping, which causes the size to be inconsistent, or the die head is not locked after the adjuster mold, and the mold height runs off during the metal stamping. 3. It is not placed in the correct position when positioning, and the die gap will increase due to the heavy chip, which will also lead to poor size. 4. The positioning of the mold is loose, and the metal stamping parts are offset when positioning, and the size of the metal stamping is poor. The above four points are the reasons for the poor size of the metal stamping parts. It is recommended that you pay attention during the operation to avoid this situation from happening repeatedly. [Related recommendation] Learn more: What are the methods for polishing the surface of stainless steel? Learn more: Manufacturing characteristics of automobile stamping parts molds Learn more: Points to note in the design of continuous stamping dies (2)