Automatic lathe processing safety operation rules

Automatic lathe processing safety operation rules: 1, the work are not allowed to drive the car in the way of braking of spindle. 2, looking for positive artifacts, only allowed with planks chuck or open the find is low speed, are not allowed to be open to find is at a high speed. 3, long tool installation shoulds not be stretched out and gasket to those points, width and bottom width. 4, loading and unloading chuck, shall turn the v-belt drive spindle by hand only back turned, absolutely forbidden to start the machine tool directly forced to loosen or tighten. Want to on the bed mat board, at the same time to prevent an accident. 5, change the direction of spindle, to stop the spindle before, are not allowed to change suddenly turning direction. Automatic lathe processing can also be used drill, reamer drill, reamer, tap, die, and knurling tools for the corresponding processing. Lathe is mainly used for machining shaft, disk, and other rotary surface of the workpiece, is the most widely used in machinery manufacturing and repair factory of machine tool for processing. The previous: hardware stamping application range