Automotive hardware stamping processing plants, what are the common problems of stamping processing + 15 years of manufacturers taking you to analyze

The hardware responsible for the manufacture of automotive hardware stamping processing plants said that regarding some common problems in stamping processing, Xiaoshuo sorted out some related materials according to actual production. Let's take everyone to understand: 1. Adhesion, scratches: due to Defects on the surface of the part or mold caused by the friction between the material and the convex mold or the concave mold; 2. Burr: mainly occurs in the shearing mold and the blanking mold, and the gap between the cutting edges is large or small, which will produce burrs; 3. Line offset: When the part is formed, the part that first contacts the mold is squeezed and formed a line; 4. Concave and concave: foreign matter (iron filings, rubber, dust) mixed in the uncoiling line causes convex and concave; 5. Tortuous: due to stress Unevenness, poor drawbead matching, or poor control of the press slider, etc. cause tortuosity and strain at the r corner or embossed part of the part; 6. Wrinkles: due to poor press slider adjustment, low press accuracy, and air cushion pressure Improper adjustment, large punches or r-parts cause wrinkles on the edges or r-parts. Hardware, 15 years of focus on automotive hardware stamping processing plants, 5000 square meters production workshop, hundreds of precision processing production equipment, more than 20 Ru0026D and design engineers, monthly processing capacity of 100+ sets of molds and daily production capacity of 3 million punching times, stamping accuracy can be Up to 0.01mm, 16 quality inspection layers are strictly checked. It can quickly solve the urgent problem of time when choosing hardware stamping processing, solve the problem of stamping accuracy, and solve the problem of production quality. Over the past 15 years, I have been conscientious and dedicated to the results of your needs only for the results of your work!