Bazhou Kangxianzhuang Hardware Stamping Parts Factory, common mistakes in stamping processing + 15 years of stamping experience

Bazhou Kangxianzhuang Hardware Stamping Parts Factory puts forward a few points about the common mistakes of stamping processing. Xiaoshuo collected some relevant information, and I will share with you below: 1. The depth of the upper die into the lower die is too large during precision stamping. 2. There is an eccentricity between the pressure center of the precision stamping processing and the pressure center of the punching machine. 3. The precision stamping processing pressure exceeds the nominal pressure of the punching machine. 4. The fixed upper mode fine punching die has a large cavity under the mold base. 5. The movable upper mode fine punching die punching Parts with multiple holes or large inner contours 6. The heat treatment hardness of the upper and lower molds of the stamping die is lower than 55HRC. Hardware, 15 years of ingenuity and focus on metal stamping parts, 20,000+ sets of mold customization production experience, monthly 100+ sets of mold processing capacity, The daily production capacity of 3 million punching times, the punching accuracy can reach 0.01mm, and the 16 quality inspections are strictly controlled. You can quickly solve the time-critical problem of precision stamping parts, solve the problem of stamping accuracy, and solve the problem of production quality. Choose, choose to rest assured!