Beijing stamping parts processing, mold processing and production encountered problems and methods of warping

Beijing stamping parts processing, I will share with you how to solve the problem of flattening and warping edges in mold processing and production: Xiaoshuo will understand with you: Reasons: 1>. The pre-folding line is too shallow and The position is wrong or the crimping punch has no pressure line or the pressure line is too shallow 2>. The height of the pressing block of the flattening die is not enough and not crushed (including insufficient mold height) 3>. The gap of the smoothing block is too large 4> The material is too hard to solve Countermeasures: 1>. Adjust the depth and position of the pressure line 2>. Increase the height of the push block 3>. Adjust the gap of the push smooth block 4>. Replace the material or trim the width and depth of the pre-folding pressure line. Hardware, 15 years of ingenuity focusing on Beijing stamping parts processing, 20000+ sets of mold customization production experience, monthly 100+ sets of mold processing capacity, daily production capacity of 3 million punches, stamping accuracy up to ±0.01mm, 16 quality inspection layers For quality control. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose to rest assured!