Causes and countermeasures of various bad phenomena on the surface of stamping parts

During the design work, we have no way to predict all the problems that may be encountered in actual production. Therefore, when the stamping parts are produced, more or less unexpected conditions will occur, such as stamping products. Some undesirable phenomena have appeared on the surface of, so how can we solve this problem? In the first case, various scars and machine deformations appeared on the surface of the stamping parts. In response to this problem, we believe that it may be caused by many reasons. For example, it may be due to the operator's operating error, which caused abnormal phenomena such as displacement or collision of the workpiece during feeding and discharging, or the technical parameters of the related equipment were not adjusted to the appropriate range. Another reason is that in the process of processing, there are some problems with the station equipment, such as overload, collision, overlapping stacking, overturning, and overspeed. In the second case, the stamping parts have unevenness. After analyzing this problem, we found that it is mainly caused by factors such as materials, molds and machines. For example, the material used is not up to standard, or the cleanliness of the material is not enough; or there are bumps in the mold; or the machine speed setting is unreasonable, etc., these factors will cause this problem. Therefore, if we want to avoid this phenomenon, we must not only strengthen the inspection of stamping materials to ensure that the materials meet the requirements for use and have good cleanliness; but also regularly check and maintain the mold to keep it stable. Status; In addition, during the processing, the production speed must be controlled to ensure the quality of the product. The above is about several common problems that may be encountered in the process of stamping parts processing. I hope that through the introduction of this article, everyone now has a deeper understanding and understanding. In the future production process, you can Avoid these problems as much as possible to ensure the pass rate of stamping products. Related news: The characteristics of the main materials of stamping parts, the treatment of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections