Causes and treatment methods of roll material problems in stamping parts

When producing stamping parts, friends who know the industry will know that many different factors will be affected in this process. Under the action of these factors, it is easy to cause some undesirable phenomena. For these problems, we need to promptly To process. Among them, the coil problem of stamping parts is a relatively common phenomenon. When the stamping parts are processed, if there is a coil problem, then the quality of the product will also be negatively affected. Therefore, if you want to get better product quality, you must do everything possible in the production process. Avoid this kind of problem. Then, in the production process, what aspects should be paid attention to? Let's take a look at the specific content. Of course, the manifestation of the coil problem is also different. We need to analyze it according to the specific situation. For example, if the coil of the stamping part is found to exist in the same state as a scar, then the main reasons we should consider are: foreign matter peeling off, steel plate surface Or foreign matter has been mixed inside. There is also a situation where the coil material appears to be damaged at the edges and corners. For this situation, we believe that the factors that should be considered are: deformation caused by uneven stress, or wrinkles. In addition, there are several more common situations, namely: 1. The roll material has bulge. In this case, it can be analyzed that the roller slips and foreign matter enters the back of the roll material. 2. Surface scratches. The situation is caused by the surface of the roller or foreign matter; 3. Irregular damage to the edge of the stamping part, which may be caused by the unsatisfactory quality of the material outside the rules. The above content is about the main content of the stamping parts coil material. I hope that the sharing of these content can attract everyone's attention. In fact, the problem of coil material in stamping parts is mostly caused by foreign objects, so attention should be paid to inspection during production to avoid the existence of foreign objects. Related news: The characteristics of the main materials of stamping parts, the treatment of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections