Design of compression mould for precision stamping parts 'hardware'

Design of the compression mold for precision stamping parts: 1. When designing the compression mold for precision stamping parts, the structure of the compression mold must be selected according to the batch size of the product, that is, for parts with small batches and simple shapes, mobile simple compression molds should be used Structure; For production parts with large batches or complex shapes, a fixed compression mold structure should be used. 2. The compression die structure designed for precision stamping parts should be simple in structure, small in size, and light in weight to reduce labor intensity during use. 3. For the compression mold of precision stamping parts that require inserts, the inserts must be easy to operate and secure, and there must be enough plastic thickness around the inserts to make the inserts firm. The general thickness can be 2- About 4mm, in order to make the inserts firmly embedded, the extrusion mold structure is used when there are more inserts. 4. Precision stamping parts are easy to be ejected from the mold after the plastic parts are pressed, so the mold cavity should be provided with an inclination of the mold. In general, the inclination of the compression mold is determined according to the inclination of the plastic product. The above is an introduction to the design of the compression die for precision stamping parts. I hope it will be helpful to you. If you need to know more, welcome to consult: