One Stop Solution Manufacturer for all kind of Stamping Products and CNC lathed products.
Detailed description and feature introduction of radial joint bearings
Detailed description and feature introduction of radial joint bearings
(1) GE-E type has an outer ring and no lubricating oil groove. It can bear radial load and small axial load in any direction.
(2) GE-ES type single-slit outer ring with lubricating oil groove. It can bear radial load and small axial load in any direction.
(3) GE-ES-2RS type single-slit outer ring with lubricating oil groove and sealing rings on both sides. It can bear radial load and small axial load in any direction.
(4) GEEW-ES-2RS type single-slit outer ring with lubricating oil groove and sealing rings on both sides. It can bear radial load and small axial load in any direction.
(5) GE-ESN type
Single-seam outer ring with lubricating oil groove and stop groove on the outer ring. It can bear radial load and small axial load in any direction. However, when the axial load is borne by the stop ring, its ability to withstand the axial load is reduced.
(6) GE-XSN type
Double-slit outer ring (split outer ring), with lubricating oil groove, outer ring with stop groove. It can bear radial load and small axial load in any direction. However, when the axial load is borne by the stop ring, its ability to withstand the axial load is reduced.
(7) GE-HS type inner ring has lubricating oil groove, double half outer ring, the clearance can be adjusted after wear. It can bear radial load and small axial load in any direction.
(8) GE-DE1 type
The inner ring is hardened bearing steel, and the outer ring is bearing steel. When the inner ring is assembled, it is extruded and formed with lubricating oil grooves and oil holes. Bearings with an inner diameter of less than 15mm have no lubricating oil grooves and oil holes. It can bear radial load and small axial load in any direction.
(9) GE-DEM1 type
The inner ring is hardened bearing steel, and the outer ring is bearing steel. When the inner ring is assembled, it is extruded and formed. After the bearing is installed in the bearing seat, the end groove is pressed out on the outer ring to fix the bearing axially. It can bear radial load and small axial load in any direction.
(10) GE-DS type
The outer ring has assembly groove and lubrication groove. Only limited to large-size bearings. It can bear radial load and small axial load in any direction (one side of the assembly groove cannot bear axial load).