Disassembly sequence and assembly sequence of metal stamping die

Stamping parts processing manufacturers, processing metal stamping parts, stainless steel stamping parts, special-shaped parts, etc. With the development of society, the mold industry is developing rapidly, and it can be used by all walks of life. Mold installation and disassembly also require a certain sequence. Yes, let’s take a look at the sequence below? The disassembly sequence of the metal stamping die is: square the metal stamping die on the bench of the fitter, hold the guide sleeve of the upper template with both hands for the small die, and then lift it up hard to separate the upper and lower dies. If it can't be separated, one person can lift the whole mold slightly away from the table top and hang it, and another person can knock it out around the lower template material once with a copper rod. Note that the separated upper mold should be placed flat on its side to avoid damage to the mold cutting edge; clamp the upper mold horizontally with a vise (note that only the template part can be clamped), and use a hexagonal wrench to unscrew the mold handle and the die fixing plate at a time And the fastening screws of the concave film, etc., and then flush out the pins. The upper mold part can be decomposed into individual die parts; the disassembly of the lower mold is basically the same as that of the upper mold, remove the elastic discharge plate screw (insert the Allen wrench from the lower cheek of the lower mold), remove the discharge rubber, and then disassemble The screws and pins of the male and female molds are disassembled at this point. Use a vernier caliper to measure and record the size of the cutting edge including the convex and concave molds. The assembly sequence of the metal stamping mold is: assembling the upper mold, the lower mold, and the upper and lower molds. The assembly sequence is just the opposite of the disassembly sequence, but pay attention; before assembling, carefully clean the mating surfaces of the pins, sockets, pusher plates, guide posts and guide sleeves with clean cotton gauze. If there is grease, it will affect the mating surfaces. The quality of assembly. The pins should be hammered in vertically with copper rods, and the screws should be tightened; when the upper and lower molds are closed, the correct positions of the upper and lower molds must be clarified, so that the typing surfaces of the upper and lower molds face the operator, and the guide posts and guide sleeves before mold closing Lubricating oil should be applied, and the upper and lower molds should be kept parallel, so that the guide sleeve can be smoothly and straight into the guide post, and copper rods should not be used to drive in. When the cutting edge of the upper die is about to enter the cutting edge of the lower die, it should be carried out slowly to prevent the upper and lower cutting edges from gnawing each other; article source: What should be paid attention to in the design of continuous die for stamping parts? Previous post: What are the processes of sheet blanking in the processing of stamping parts?