Do you know the material selection of Wuxi stamping parts and stretch materials?

Wuxi stamping parts are very particular about the choice of raw materials before stamping and stretching. If the material is not properly selected, it will not only stretch and burst, but also affect many issues such as quality and time. The following Xiaoshuo will share with you a few points: It is not advisable to use materials with poor plasticity in the deep drawing process. Due to the low degree of deformation allowed by low plastic materials, it is necessary to increase the number of drawing procedures and intermediate annealing. The material for deep drawing requires high plasticity, low yield point and good stability. The smaller the ratio of the yield point of the drawn material to the tensile strength, the better the drawing performance and the greater the limit of one deformation. The materials commonly used for deep drawing are low carbon steel, low zinc brass, pure aluminum and aluminum alloy, and austenitic stainless steel. Hardware, 15 years of craftsmanship focused on Wuxi stamping parts, 20,000+ sets of customized mold production experience, daily production capacity of 3 million punching times, stamping accuracy up to ±0.01mm, and 16 quality inspections to strictly control the quality. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose to rest assured!