Dongguan hardware stamping parts factory direct supply, stamping classification + 3 million punching capacity the next day

The staff directly supplied by the Dongguan hardware stamping parts factory said that there are two methods of cold stamping and hot stamping according to the temperature conditions during stamping. This depends on the material's strength, plasticity, thickness, degree of deformation and equipment capabilities, etc. At the same time, the original heat treatment state and final use conditions of the material should be considered. Xiaoshuo has collected some relevant knowledge, and I will share it with you below: Cold stamping: Metal processing at room temperature, generally suitable for blanks with a thickness of less than 4mm. The advantages are no heating, no scale, good surface quality, easy operation and low cost. The disadvantage is that there is work hardening, which makes the metal lose further deformation ability in severe cases. Cold stamping requires that the blank has a uniform thickness and a small fluctuation range, with a smooth surface, no spots, and no scratches. Hot stamping: A stamping process that heats metal to a certain temperature range. The advantage is that it can eliminate internal stress, avoid work hardening, increase the plasticity of the material, reduce the deformation resistance, and reduce the power consumption of the equipment. Hardware, 15 years of ingenuity and focus on the processing of metal stamping parts, 20,000+ sets of stamping die customization production experience, monthly 100+ sets of die processing, daily production capacity of 3 million punching times, stamping accuracy up to 0.01mm, and 16 strict quality inspections. check. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose rest assured!