Dongguan Metal Stamping Factory Products Co., Ltd., so that the processing of sheet materials will reduce the cost

Dongguan Metal Stamping Factory Products Co., Ltd. often uses some sheet metal in its production. Reasonable processing can not only improve efficiency, but also reduce the cost of use for customers. The following Xiaoshuo will share with you a few points: In Dongguan Hardware Stamping Factory Products Co., Ltd., the general punching process includes punching and cutting corners, punching and blanking, punching convex hull, punching and tearing, and punching. In order to meet the requirements of each process, corresponding molds are required to complete the operation, such as convex molds, tear forming molds, and so on. Flanging is to draw a slightly larger hole on a smaller base hole, and then tap the hole on it. Doing so can increase its strength and avoid slippage. Pressure riveting often uses pressure riveting studs, pressure riveting nuts, pressure riveting screws, etc. The pressure riveting method is generally completed by a punch or hydraulic pressure riveting machine, and riveting them to the stamping parts. The hardware of Dongguan Hardware Stamping Factory Products Co., Ltd. has 15 years of ingenuity and has focused on the production and production of stamping and stamping parts. It has 20,000+ sets of customized mold production experience, a daily production capacity of 3 million punches, and 16 quality inspections. It can quickly solve the time-critical problems for you, quickly solve the accuracy problems of stamping parts, and quickly solve the quality problems of mass production for you.