Dongguan's 15 years of strength stamping processing manufacturers tell you, what should you pay attention to when producing precision metal stamping parts?

15 years of precision metal stamping parts in Dongguan, precision ±0.01mm, the powerful stamping manufacturer 'Hardware' will show you what are the precautions for the production of precision metal stamping parts? 1. The adjustment method is: first turn the material thickness adjustment dial clockwise with one hand, and pull the material tape with the other hand. If the material tape can be pulled, it needs to slowly rotate counterclockwise until the data can't be pulled, and then rotate two small grids counterclockwise again. The locking screw is tightened. If the data cannot be pulled, but the data thickness adjustment dial is relatively loose when rotating clockwise or counterclockwise, you need to use your fingers to slowly rotate clockwise, but do not use strong force until it can’t rotate, and then rotate two small cells counterclockwise, and then Tighten the locking screw. The adjustment of the fixed clip is the same. 2. After the thickness of the moving clip is adjusted, the flywheel of the punch needs to be turned clockwise to 90 degrees, during which time it is necessary to check whether the moving clip is always in a clamping condition. Adjust the material thickness of the fixed clip at 90 degrees, first turn on the main switch of the clamping and releasing of the feeding clamp, place 1.5T of data on the thickness adjustment plate of the movable clamp, and hold up the material of the movable clamp without clamping the material, and then Pass the data through the fixed clip, then turn the main switch of the feed clamp clamping and release to off, and then adjust the thickness of the fixed clip according to the method of adjusting the thickness of the moving folder. 3. After adjusting the walking distance, you need to turn the main switch of the feeding clamp clamping and releasing to on, remove the data placed on the thickness adjustment plate of the movable clamp, and move the punch flywheel to the upper mold and the stripper plate. The guide needle enters the lower mold. When the float pin hole is 2/3, adjust the feeder relaxation time. 4. When the straight section of the guide needle is about to leave the material belt when the punch is shaken through 180°, it is necessary to check whether the fixing clip is clamped at the moment. If it is not clamped, adjust the data to the clamping state according to the loosening adjustment method. Hardware, from the quality inspection of raw materials for processing precision metal stamping parts, to the design, processing, and assembly of molds, to the first product and mass production, are one-to-one customized services to ensure that every small metal stamping part matches your product. 15 Years of hardware stamping experience, a processing team of more than 20 people, can produce samples in 2 days, and ship in 3 days. Can save your time to market