Features of scaffolding stamping parts

Regarding the characteristics of scaffold stamping products, everyone is already familiar with it. The main characteristics are lighter weight, thinner, and better rigidity. In fact, its standard service mainly depends on the mold, so it can maintain a relatively stable level in this regard. Under normal circumstances, there is no need to go through cutting again, which can meet the requirements of use. Generally speaking, the service grade and surface condition of cold stamping parts are better than those of hot stamping parts. In recent years, the technical level of domestic related industries has been continuously improved, and at the same time, the level of equipment and other aspects has been significantly improved. In this context, the production technology of domestic scaffold stamping products has also made some progress. It can be said that to a certain extent, the level of stamping skills has been raised to a new height. Therefore, in practical applications, it can also meet the needs of more users and friends. Acoustic tube steel pipe has two types of installation, double-row and single-row. The requirements are as follows: 1. The operating layer of the acoustic tube steel rack 1. A full-length railing should be erected along the outer row of the rack. 2. When installing a single-row acoustic measuring pipe steel pipe rack at the window, a short steel pipe should be added to the outside, and the small cross bar is connected with the short steel pipe with acoustic measuring pipe. 3. When erecting the acoustic measuring tube steel pipe rack with a height of more than three steps, a connecting wall rod must be installed. The method of connecting the wall rod is to lengthen the small cross rod and tie the outer wall of the house to the wall. 4. When installing the acoustic measuring tube steel pipe rack at the door side channel, the vertical rods and large cross bars of some of the racks should be hollowed out, and two steel pipes shall be added for the arrangement of the splayed brace. The crossbars are connected by acoustic measuring tubes, so that the upper layer load is transmitted to the ground through the figure-head brace. 5. Set up steel pipe racks. When the erection height is more than seven steps, cross braces must be installed. The cross braces are installed at the corners and ends of the acoustic tube steel pipe rack and at every 30m along the longitudinal direction. Each cross brace occupies two spans. The steel pipe racks are arranged continuously from bottom to top, and the lower pair of cross braces must fall to the ground. Related news: The characteristics of the main materials of stamping parts, the handling of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections