Flat washer manufacturers, share with you about the processing technology of flat washers [hardware]

For flat washer manufacturers, the specifications of flat washers are roughly divided into two types: standard parts and non-standard parts. Standard parts are produced according to GB models. Rather than standard parts, most of them are flat washers customized for different products and sizes of customers. And what process does the flat washer have in the production process? Xiaoshuo shares with you: Flat washer processing technology: There are two main flat washer processing technologies, one is deburring treatment and the other is surface protection treatment; for deburring treatment, the washer should be removed by polishing, vibration or other methods Burr and flash. Surface protection treatment. The surface treatment of gasket products in the standard is divided into coating (thick) and plating (thin). The author believes that it should be equally applicable to other fastener products-bolts (screws, studs) and nuts. Although in other Some corresponding standards are not as specific as the standard description. Warm reminder: If there are no other regulations for non-protective layer gaskets, the surface of the gasket should be an ordinary surface, that is, there is no other coating (plating) layer except for anti-lubrication. , 15 years of ingenuity and focus on flat washer manufacturers, 20,000+ sets of mold customization production experience, monthly 100+ sets of mold processing capacity, daily production capacity of 3 million punching times, stamping accuracy up to 0.01mm, and 16 quality inspections strictly. You solve time-critical problems, solve stamping accuracy problems, and solve production quality problems. Choose, choose, rest assured!