Flat washer manufacturers, tell you what to pay attention to when testing flat washer

Flat washer manufacturers, after the completion of the production of the mold of the flat washer, they must first enter the trial mode. How to operate during mold trial, and what should be paid attention to? Xiaoshuo will share with you: When you try the mold for the first time, you must slowly close the upper mold. When there is a stretching process, you must use a fuse to test the thickness of the material. After the material gap reaches the thickness of the material, try the mold again. It must be right first. Please use movable inserts to adjust the height of the drawbead. When testing the mold, the reference hole and reference surface must be matched with the mold before the product is measured on the gage, or sent to the CMM for 3D report, otherwise it is meaningless. The red lead must be well matched, and the fit rate reaches more than 80%, before the cut can be opened and the CMM report can be made. Perhaps the reference hole has been matched, the product is very stable, and the fit rate can be appropriately reduced. The distribution of red lead is very important. Otherwise, the product is unstable and cannot be judged for later modification, and the part size will not meet the customer's requirements. When adjusting the mold, most of the gaskets are used to adjust the height of the forming male, or the forming male parts may be moved left and right back and forth. The gaskets generally use stainless steel hard plates. Hardware, 15 years of ingenuity and focus on flat washer manufacturers, 20,000+ sets of customized mold production experience, monthly processing of 100+ sets of molds, daily production capacity of 3 million punches, stamping accuracy up to 0.01mm, and 16 quality inspections. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose rest assured!