Flat washer mold manufacturers, what are the causes of burrs on flat washers

Flat washer mold manufacturers, the flat washer and mold produced by it determine the quality and efficiency. When the flat washer produces burrs during production, Xiaoshuo will share with you the possible situations of the mold: 1. If the gap is too large, the burrs of the stamped workpiece will be relatively large and the stamping quality will be poor. If the gap is too small, although the quality of the punching is better, the wear of the die is more serious, greatly reducing the service life of the die, and it is easy to cause the punch to break. 2. If the gap is too large or too small, it is easy to cause adhesion on the punch material, resulting in stripping during punching. If the gap is too small, it is easy to form a vacuum between the bottom surface of the punch and the sheet material and cause the scrap to rebound. 3. Reasonable clearance can prolong the life of the mold, the discharge effect is good, the burr and flanging are reduced, the plate is kept clean, the hole diameter is the same, and the plate is not scratched, the number of sharpening is reduced, the plate is straight, and the punching positioning is accurate. Hardware, 15 years of craftsmanship and focus on flat washer mold manufacturers, 20,000+ sets of customized mold experience, daily production capacity of 3 million strokes, stamping accuracy up to 0.01mm, and 16 quality inspections are strictly controlled. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose rest assured!