Hardware stamping parts processing manufacturers, responsible for customer results + 4 kinds of material storage methods [Hardware]

Metal stamping parts processing manufacturers often encounter the phenomenon of custom stamping parts for customers and stocks of some metal raw materials. However, most of the raw materials will cause oxidation and rust problems. If it is not kept properly, it will have an impact on the customer's use, and severely will cause direct losses. Xiaoshuo will share with you several common storage methods for metal materials today: 1. Choose a storage location. 1. Different metals have different places. Large and medium-sized metal materials, such as round steel and square steel, can be placed directly in the open field. Galvanized iron plates, tinplate and small steel wire ropes can be stored in the warehouse, and valuable metals and hardware products should be stored in the closed warehouse of the stamping plant. 2. The warehouse for metal storage in the stamping plant should be far away from plant buildings that produce harmful gases and dust. 3. Metal materials and products should be stored separately from acids, alkalis, salts, etc. 2.   Warehousing inspection is to be done. Before the metal is put into storage, strict inspection should be carried out and the metal surface should be cleaned to remove water marks, oil stains, mud and other stolen goods. For rusty materials, rust should be removed in time. 3. Reasonable stacking and padding. Keep the bottom of the metal material ventilated and dry, so as to protect the metal from the influence of moisture on the ground; temporarily place the metal outdoors to be covered to isolate it from rain and humid air. Fourth, although most of the stamping plants are open to the environment, the humidity of the warehouse must be controlled. If the relative humidity is below 60%, it can prevent the surface of the metal from condensing moisture, thereby forming an electrolyte layer and subjecting it to electrochemical corrosion. However, since the humidity is difficult to reach below 60%, it can generally be controlled below 65%-70%. 15 years of hardware stamping parts processing manufacturers, see the management from the subtleties. Responsible for every customer's result, work hard for every customer's needs, and be happy for every customer's satisfaction. Let you choose when choosing a manufacturer of metal stamping parts, and let you choose worry, rest assured, and peace of mind!