Hardware tells you the basic causes of poor hardware size

Hardware tells you the basic reasons for poor hardware size! Metal stamping parts can be seen everywhere in our lives, but when the metal stamping parts are processed, the size of the metal stamping parts may be poor. Why is this? The following metal stamping manufacturers briefly analyze. Reasons for poor size of metal stamping parts: 1. Poor size due to poor mold design or processing and assembly. This situation generally occurs during the first production. 2. The height adjustment position of the mold does not match when setting the mold, the mold cannot be in place when the hardware is stamped, resulting in the size not matching, or the die head is not locked after the adjuster mold, and the mold height runs off during the hardware stamping. 3. When positioning, it is not placed in an accurate position, and the die gap will increase due to the heavy chip, which will also lead to poor size. 4. The positioning of the mold is loose, and the metal stamping parts are offset when positioning, and the size of the metal stamping is poor. The above 4 points are the reasons for the poor size of metal stamping parts. In order to avoid this situation from happening repeatedly, it is recommended that everyone pay attention during the operation. The above is the introduction of the hardware author. I hope it will be helpful to you. If you need to know more information about stamping parts, please consult the hardware that has been dedicated to stamping parts industry for 15 years