How does the hardware plan the production and design standards of metal stamping parts?

During the production of metal stamping parts, we often encounter crushing or scratching of metal stamping parts, or the untidy workshop during production. This not only affects the 7S workshop but also increases the production cost. In order to avoid these To discover the phenomenon, we should plan the production of metal stamping parts and formulate design standards. Production planning of metal stamping parts: 1. A strict inspection system must be established during production. The first metal stamping parts produced every day must be thoroughly inspected, and the inspection must be passed before it can be put into production. At the same time, it must be strengthened. Make inspections, and deal with them in time if accidents happen. 2. During the stamping process, the mold cavity should be kept clean, and the orderly processed workpieces in the workplace should be placed neatly. 3. Adhere to a civilized production system. For example, the transfer of metal stamping parts and accessories must use appropriate workstations, otherwise the surface of the workpiece will be crushed and scratched and the surface quality of the workpiece will be affected. Hardware stamping design standards: 1. When designing metal stamping parts, it should be ensured that under normal use, the dimensional accuracy and surface roughness requirements should be as low as possible, and it should be beneficial to the exchange of metal stamping parts. , Reduce waste, ensure the stability of the quality of metal stamping parts. 2. When designing metal stamping parts, the existing equipment, process equipment and procedures should be used as much as possible to process the metal stamping parts, and at the same time, it should be beneficial to prolong the service life of the stamping die. 3. The designed stamping parts must be conducive to improving the utilization rate of metal materials, reducing the types and specifications of materials, and reducing the consumption of materials as much as possible; using low-cost materials where permitted, and making the parts as waste-free and as possible Less waste arbitration. The above is a brief introduction on how to plan the production of metal stamping parts and design standards. After everyone has passed the above learning, Xiaoshuo hopes that everyone will be helpful in designing metal stamping parts or planning the production of metal stamping parts.