How to deal with poor processing and polishing of stamping parts in hardware?

There are many stamped products used in the appearance of the product, which need to be polished. Polishing one by one by hand, firstly, the defects of the product are not fixed, and there is no standard for the length of polishing time, and there is no standard for the heavier and lighter ones. Therefore, the products processed by this kind of stamping parts are most prone to quality problems. How to improve the yield of processed products of such polished stamping parts is a headache for many hardware factories and customers. Hardware, since this kind of problem has appeared too many times, let me talk a little bit about my feelings. The first is to improve the quality of the product in the production, reduce or eliminate indentation and strain. The second is the preliminary exploration standard of polishing, how to control the key position of the master, how long it takes to throw, and the master's self-inspection after the throw is completed, and the defects will be resolved immediately. The third is the responsibility and efficiency of the polishing quality staff. The processed products of the cleaned stamping parts can be inspected quickly and accurately by the quality staff, and the defective products are clearly marked. Improved efficiency and improved quality are the profit of each stamping processing product and the benefit of customers. Sharpening the knife without accidentally cutting firewood, and hardware has continuously improved these three points through experience, which has greatly improved efficiency and quality. To provide you with high-quality stamping parts processing manufacturers: