How to ensure every detail of stamping and forming

Stamping is a metal processing method, which is molded on the basis of plastic deformation of metal materials. It uses molds and stamping machine tools to press the material to cause plastic deformation or separation of the material, and then obtain a certain design, specifications and characteristics. Parts (stamping parts). Only by paying attention to every detail of stamping, can production and processing be carried out more efficiently. Next, we will discuss how to ensure that every detail of stamping is correct. The key points of stamping and forming are as follows: before stamping, there needs to be material correction and adjustment processing process or fully automatic calibration tooling equipment to ensure that the raw materials enter the mold core smoothly and smoothly, and the position of the material belt on the feeding clamp must be clearly defined. The total width gap between the two sides of the material belt and the two sides of the feed clamp is clearly defined and implemented. Whether the stamping slag can be cleaned up immediately and reasonably without mixing or sticking to the stamping parts. The material in the overall width of the coil requires 100% supervision to prevent poor raw materials from producing poor stamping parts. Whether the end of the coil can be supervised or not, when the coil is expected to end, the entire stamping process will be automatically interrupted. When operating procedures, it is necessary to clearly define the reaction method when the product is left in the mold when an abnormal shutdown occurs. When the material belt enters the mold, it is necessary to have error-proofing equipment to ensure that the raw materials can enter the appropriate part of the mold. Continuous molds or loading molds require step-by-step detection. If the part does not come, an alarm or automatic shutdown is required. The stamping die needs to be equipped with a detector to detect whether there can be a product stuck in the core, if there is a stuck, the machine equipment is automatically interrupted. Can the main parameters of the whole process of the stamping die be supervised? When there are abnormal main parameters, the stamping parts need to be automatically destroyed under this parameter. Whether the management method of stamping die can be implemented reasonably (plan and implementation of protective maintenance, maintenance of spare parts is determined) The cleaner used to blow away the slag must define the blowing position and direction. [Related recommendation] Learn more: What are the methods for polishing the surface of stainless steel? Learn more: Manufacturing characteristics of automobile stamping parts molds Learn more: Points to note in the design of continuous stamping dies (2)