How to maintain high-speed stamping dies in the daily processing of stamping parts?

The stamping equipment used by stamping parts processing manufacturers has its own unique functions and requires our daily maintenance to extend its service life. So how should we operate the daily maintenance of high-speed stamping dies? The stamping manufacturer will take you to take a look; 1. For high-speed stamping dies with a knife edge clearance of less than 0.02mm or a monthly output of 50,000 stamping parts with a total output exceeding 1 million, the punch is relatively easy to break and wear, we should design a quick-change structure , The punch clearance of the stripper plate is one side +0.01mm sliding. The cutting edge of the lower die is to be an insert. The inserts and movable blocks that are easy to block the material are designed to be screw-in type, and the mold teeth are tapped or the lower seat cushion is added with an ejection hole. 2. For high-speed stamping dies whose sheet thickness is less than (inclusive) 0.3 or whose monthly output of stamping parts is 50,000 pieces and the total output exceeds 1 million pieces, the stripper plate and the lower die shall be designed with auxiliary guide bushes. 3. When high-speed stamping, the circular punch with a diameter less than 2.0 or a special-shaped punch with an equivalent side length less than 1.5 should be used as a reinforcement or a supporting punch, and if necessary, a secondary supporting insert in the stripper. 4. During high-speed stamping, for round holes with a diameter of less than 1.2 or special-shaped holes with a side length of less than 1.2, inserts should be inserted in the stripping plate, and the stop baffle is designed to support the hole of the punch (direct order +0.01~0.015mm, The stop baffle cuts the pin positioning). 5. The size of the die base of the high-speed stamping die should be adapted to the parameters of the punch table and the height of the closed die. Article recommendation: Principles and characteristics of the four-column press for stamping parts processing equipment Previous: Five characteristics of the aluminum strips of the nose bridge of the N95 mask produced by the manufacturer