How to remove rust from precision stamping parts

Precision stamping parts are widely used in life, involving all aspects. However, in daily use, some problems may also occur. For example, the appearance of rust on the surface is one of the common problems. So, what should we do after the precision stamping parts rust? Let me tell you with precision. Soaking cleaning method: add a special type of cleaning source liquid to the tank (using plastic or stainless steel plate tank, which can reduce the penetration of ferrous ions into the source liquid and reduce the use period); use an electric heating device to heat to 40-50 degrees And maintain, the time can be extended at room temperature; the precision stamping parts can be immersed into the tank; if the efficiency needs to be further improved, the circulating water pump can be used to mix the tank liquid; after all the rust is melted, the stamping parts are removed and used Water-based anti-rust oil is used for soaking; after soaking, it is of course dry or air-dried, or immediately carried out de-drying and anti-rust treatment; when necessary, carry out anti-rust treatment and transfer to the next process flow. Scrub cleaning method: use towel to scrub continuously. This method is suitable for cleaning and rust prevention of large and medium-sized machinery and equipment or high-precision stamping parts; after scrubbing, use warm air to dry or apply rust inhibitor after drying. It's okay. [Related recommendation] Learn more: What are the methods for polishing the surface of stainless steel? Learn more: Manufacturing characteristics of automobile stamping parts molds Learn more: Points to note in the design of continuous stamping dies (2)