How to solve burrs in stamping parts processing to provide customers with more qualified products-hardware

Burr produced by stamping parts is a very common problem. If it is not handled in time, the lighter ones will cause bad loss of stamping parts, and the more serious ones will cause the customers to increase the cost during use and the products are not qualified. How should stamping parts be processed to solve this problem and provide better stamping parts to customers? The blanking gap is too large, too small or uneven; the cutting edge of the working part of the die becomes blunt; the center line of the punch and the die changes due to long-term vibration and impact, and the axes do not coincide, resulting in single-sided burrs. Countermeasures to ensure the processing accuracy and assembly quality of the male and female molds, ensure the verticality of the male mold and bear the side pressure, and the entire die must have sufficient rigidity; when installing the male mold, the correct clearance of the male and female molds must be ensured and the male and female molds are fixed in the mold The board should be installed firmly, and the end faces of the upper and lower molds should be kept parallel to the work surface of the press; the press should have good rigidity, small elastic deformation, high precision of the track and the parallelism of the backing plate and the sliding block; Requirement The press must have sufficient punching force; hardware, 15 years of ingenuity and focus on stamping parts processing, 20000+ sets of mold customization processing and production experience, product accuracy can reach 0.01MM, daily production capacity of 3 million strokes and 16 strict quality inspections For quality control. It can quickly solve your time-critical problems, solve your product accuracy problems, and solve your stamping parts processing quality needs. Choose, choose rest assured!