How to solve the material jam when processing the punching mesh screen

When the small hole factory first punches the mesh screen, sometimes it is unavoidable to avoid the jam. So why is there a jam in the mesh? How to solve this trouble? Xiaokong factory tells you! The reasons for the jamming of the punching mesh screen during processing: improper adjustment of the feeding distance, material pressing and loose adjustment of the feeder; the feeding distance has changed during the stamping process; the feeder has a problem; the punching material radian and width are out of tolerance And the burrs are large; the punching die processing is abnormal; the guide hole diameter is insufficient, and the upper die pulls the material; the guide plate shedding performance is not set; the mold frame is not set properly, which causes the verticality of the feeder to become poor. There are the above eight reasons for the hole jam of the punching mesh in the small hole factory, and the following eight solutions. The solution to the material jam in the small hole factory mesh: adjust the feeder again; adjust and repair the feeder; replace the punching material and control the quality of the incoming material; eliminate the sickle bend of the material belt; punch the positive hole concave and convex mold; adjust the release The strength of the material spring; correct the material guide to prevent the tape from being taped; set up the mold from the beginning.