How to use electronic stamping parts with higher specification accuracy

Electronic stamping parts have high specification accuracy when used, and together with the uniform specifications of the mold parts, they have better interchangeability. It can meet general equipment and usage requirements without further machining. Electronic stamping parts are manufactured by stamping under the premise of low consumption of materials. The parts are light in weight and rigid, and after the sheet metal is plastically deformed, the internal arrangement of the metal is improved, so that the strength of electronic stamping parts is improved. improve.　　In the stamping process, the surface of the material is not damaged, so the electronic stamping parts have a good surface quality and a smooth and beautiful appearance. This provides convenient conditions for surface painting, electroplating, phosphating and other surface treatments.　　How to prevent the damage of the metal stamping parts? 　　1. The type, specification and function of the hardware fittings should conform to the current specifications and relevant regulations, and match the selection of plastic steel doors and windows.　　2. For sliding windows with a width of more than 1 meter, or double-glazed doors and windows of equipment, double pulleys should be installed, or roll pulleys should be used.　　 3. The sliding hinge shall not be made of aluminum alloy, but stainless steel shall be used.　　4. For hardware with fastening screws, it is necessary to install a metal lining plate. The thickness of the lining plate should be at least twice the pitch of the fasteners. It must not be fastened to plastic profiles, and non-metal linings must not be used.　　5. Hardware accessories should be the final equipment. Door and window locks, handles, etc. should be assembled after the window and door leaves are put into the frame to ensure that the orientation is correct and the switch is flexible.　　 6. After the hardware stamping equipment, pay attention to maintenance to prevent rust and corrosion. In daily use, lightly close and lightly open to prevent hard closing and hard opening, which may cause damage. No noise. With the current nylon wheels, not only does it push and pull without noise, but it is also smoother and lighter. The service life is not shorter than that of the above various pulleys. To make (doors) and windows operate normally and smoothly, they must provide (doors) and windows. Choose a high-quality pulley. On the surface, the inferior pulley has a rough workmanship, no smoothness, inflexible sliding, small and light. The above is the content that has not been shared by everyone, I hope it will be helpful to everyone. Dongguan Hardware Co., Ltd. has been dedicated to precision metal stamping dies, precision metal stamping, metal stamping parts, stamping parts processing and other fields with 15 years of ingenuity. After more than ten years of development, it has a complete set of high-precision equipment and technical team as well as sound scientific management in the precision metal stamping industry. It has a monthly processing capacity of 100 sets of precision molds and a daily production capacity of 3 million strokes.