Huizhou Dongguan hardware stamping parts, common problems in stamping processing + 15 years of experience manufacturers will show you

Huizhou Dongguan hardware stamping parts, about some common problems in stamping processing, Xiaoshuo sorted out some relevant information, and let everyone know about it together: 1. Adhesion, scratches: due to friction between the material and the punch or die Defects appearing on the surface of the part or mold; 2. Burr: mainly occurs in the cutting die and blanking die. The gap between the cutting edges may be large or small, and burrs will be produced; First, the part contacting the mold is squeezed to form a line; 4. Concave: foreign matter (iron filings, rubber, dust) mixed in the uncoiling line causes convexity and concavity; 5, twists and turns: due to uneven stress, poor matching of drawbeads or Poor control of the press slider, etc., caused twists and strains at the r-corner or embossed part of the workpiece; 6. Wrinkles: due to poor press slider adjustment, low press accuracy, improper adjustment of air cushion pressure, punch or r part Major causes such as wrinkles on the edges or r parts. Hardware, 15 years of focus on hardware stamping parts in Huizhou, Dongguan, 5,000 square meters production workshop, hundreds of precision processing production equipment, more than 20 Ru0026D and design engineers, monthly processing capacity of 100+ sets of molds and daily production capacity of 3 million punching times, stamping accuracy can be Up to 0.01mm, 16 quality inspection layers are strictly checked. It can quickly solve the urgent problem of time when choosing hardware stamping processing, solve the problem of stamping accuracy, and solve the problem of production quality. Over the past 15 years, I have been conscientious and dedicated to the results of your needs only for the results of your work!