Installation steps of progressive die

Installation steps of progressive die: 　　 (1) Clean and level the mold mounting surface (the bottom surface of the slide block, the top of the worktable); 　　 (2) Move the slide block to the upper dead point of the stroke, adjust the slide block near the upper limit, and then Insert the mold into the set position in the press. After confirming that the mold has indeed hit the positioning pin, put down the mold lifter. Fix the lower mold with fastening bolts or lower mold clamps on the work surface; 　　(3) Use the inching mode to lower the slider to a few millimeters above the upper mold; 　　(4) Use the slider to adjust and lower the slider again , Until it touches the upper mold, at this time, fix the upper mold on the bottom plate of the slider with a fastening bolt or an upper mold clamp; 　　 (5) Use the slider to adjust the slider to raise the slider by a few millimeters, and then remove the mold for storage. Parts; 　　(6) Set the closed mold height to a few millimeters higher than the predetermined closed mold height; 　　(7) At this closed mold height, use the inching mode to operate. After judging that there is no abnormality, stop the slider at the bottom dead center, and clamp the lower die with a fastening bolt or a lower die clamp; 　　(8) return the slider to the top dead point; 　　(9) reset the closed mold height to the predetermined The closing height of the mold, that is, the closing height of the mold during mold design; 　　(10) the connection of accessory devices such as misclamping (misfeeding) detection; 　　(11) confirm the product removal and waste disposal device; 　　(12) set the mold buffer device , Ejector device and balance the pressure of the cylinder; 　　 (13) adjust the timing control of all actions.