Installation steps of solar stamping die

The installation of solar stamping parts molds is a very important process. If the molds are not installed in place, it will cause problems such as improper use of high-speed punches and substandard precision of stamping parts. 1. Adjust the closing height of the high-speed punch slider. Closing height explanation: the distance between the slider and the platen when the slider moves to the bottom dead center. 2. Raise the slider, put the mold on the platen, and the lower convex and concave molds should be aligned with each other, with a uniform gap. 3. Put the mold handle of the mold into the mold handle mounting hole of the slider and raise it to the bottom dead center position. 4. Press the slider against the mold, and tighten the screws of the upper mold handle of the slider. 5. Then press the lower mold tightly with a pressure plate. 6. Then adjust the depth of the upper die into the concave die, and then let the punch run idly for a few turns. 7. Raise the slider to the top dead center position, adjust the punching rod stop screw until it is tight enough, and then run it idling several times to observe whether the mold is tight. 8. After the installation is completed, check whether the fastening screws of the mounting base of the solar stamping die are properly locked. In the trial operation, pay attention to whether the material can be unloaded and shipped smoothly. If there is no abnormal situation, it can be officially put into production. Solar stamping parts molds for precision production can be free of mold design costs. When the agreed delivery quantity is reached, the mold cost will be refunded. The stamping production efficiency is high and the processing cost is saved. Precise contact information: Precise wishes everyone a prosperous business and all the best. If you want to learn more, you can scan the following QR code and follow the official account. , Committed to the world's most professional precision stamping processing plant for electronic parts