Introduction to several characteristics of scaffolding stamping parts processing

When scaffolding stamping parts are processed, they often show some obvious characteristics. Do you know what the degree has? I believe everyone is more interested in this issue. Then we will give you a brief introduction, hoping to help you, and at the same time, we hope to deepen your knowledge and understanding of scaffold stamping parts. First of all, let's take a look at the first characteristic that is displayed during the processing of scaffold stamping parts. We can clearly see that the pressure perpendicular to the direction of the board surface, although not very large, is sufficient to ensure a certain deformation of the workpiece. For this problem, we can understand it this way. Under normal circumstances, the pressure perpendicular to the plate surface is very low and not enough to consume the internal stress generated by it. Therefore, most of the stamping deformation can be regarded as a state of plane stress To deal with it, in this way, the workload can be greatly reduced when performing analysis. Another feature is that after this processing method, the relative thickness of the obtained scaffold stamping parts is often very small. Therefore, under pressure, its anti-instability performance is not ideal. Therefore, if there is no anti-instability device, it may not be able to successfully complete the stamping work in the free state. In addition, during stamping and forming, the value of the internal stress of the blank must not exceed the yield stress of the material. In addition, I don't know if you understand that, in many cases, the blanks of scaffold stamping parts actually have a certain degree of freedom, often only a certain surface is in contact with the mold. Therefore, in such a case, the part of the blank can be deformed because the mold exerts a certain force on its adjacent part to be formed. In short, in the processing of scaffold stamping parts, such characteristics may be shown. Studying these contents will help us to better carry out the next step and also help us to further improve the quality of processing. Related news: The characteristics of the main materials of stamping parts, the treatment of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections